Prepare the carousel
Start by assembling the baskets onto the telescopic rod. Pull the rod apart and slide it up through the centre of the basket, ensure the plastic foot is under the first basket. Take the second foot and slide it over the rod then slide the basket on top of this. You should have a plastic foot under the first basket and in-between the first and second baskets.
Put this aside and prep the cabinetry.
Unclip the door, to allow you as much working space as possible. Just push the button in the back on the door’s hinges to release it.
If you have a centre shelf you will need to remove it, use a jigsaw to cut it in half to do this. Remember to wear safety gear, and take care when doing this.
Measure the width of the cabinet and locate the centre point, place a centre mark on the bottom shelf and on the underside of the benchtop.
Take the plastic foot provided and place it directly over your centre mark on the cabinet base. Screw it down with the four screws provided.
Now go back to your carousel, insert the telescopic head into the centre rod of the carousel unit and slide the complete unit into the cupboard.
Line up the plastic foot of the centre rod with the plastic foot that is screwed to the cabinetry base so that they slot together.
Extend out the telescopic head to the underside of the benchtop and align with your centre mark. Insert the four screws as you did on the bottom of the cabinet.
Now insert the single stainless steel screw into the shaft that holds the telescopic stay in position.
Lift up the basket, and install the stainless steel pins into the centre shaft at set the height of your baskets. Swivel the basket until it locates in place.
Fit the door back to the cabinetry.