Nail your two sides onto your base ensuring that the sides are sitting hard on& the ground.
Step 2
Slip the first end piece in between the sides sitting on the bottom board.
Step 3
Nail the first end on, three nails evenly spaced through each of the side boards and two through the base.
Step 4
Before you put the other end on, place in your handle into the end you have already fixed.
Step 5
Now put your other end in and nail in place as you did for the first.
Step 6
Place a nail through the pre-drilled hole through the top of your ends into the handle. Hammer into place.
Step 7
Use a hand plane around the edges of the timber.
Step 8
Give the tool box a sand to remove any sharp edges.
Step 9
Use a stain or oil to finish off the toolbox.